WARNING:
JavaScript is turned OFF. None of the links on this concept map will
work until it is reactivated.
If you need help turning JavaScript On, click here.
This Concept Map, created with IHMC CmapTools, has information related to: Preparation of Main Plant for Manoeuvring from in Port Condition 2, Check and inspect the steering gear systems by Ensuring the LO levels and hydraulic oil levels are correct. making sure that As each unit is tested, check all movements of the rams and rudder are satisfactory and as required. Maintain contact with the bridge as these tests are undertaken., Main boilers superheated steam stop valves to the main turbine once the main steam line pressure is at normal. changeover to using steam to power turbine Full Steam Injection, When steering gear tests are completed, Prevent the pumps from delivering in the same mode for long periods and risk overheating of the unit by Ensuring the deck officer alters the rudder angle regularly to overcome this. open slowly Main boilers superheated steam stop valves to the main turbine once the main steam line pressure is at normal., As each unit is tested, check all movements of the rams and rudder are satisfactory and as required. Maintain contact with the bridge as these tests are undertaken. and paying close attention to When steering gear tests are completed, Prevent the pumps from delivering in the same mode for long periods and risk overheating of the unit by Ensuring the deck officer alters the rudder angle regularly to overcome this., Proceed with the following test: 1. With the main turbine controls on manual-stop, 2. Move the telegraph lever to all its points, 3. Prove the turbine room control unit follows and answers the bridge unit. then Check and inspect the steering gear systems by Ensuring the LO levels and hydraulic oil levels are correct.